Dynabrade 61375 Betriebsanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Elektrowerkzeug-Zubehör Dynabrade 61375 herunter. Dynabrade 61375 5 Seiten. 8" random orbital head

Seite drucken

Power Tool/Random Orbital Head Assemblies

Dynabrade Models

Ready To Accept Accessory:

Electric: 51610

Premium Air: 51392, 51396 (M14)

Autobrade Air: 18050, 18053 (M14)

11.3 N•m

Random Orbital Head Installation Procedure:

1. Make spindle stationary; use spindle lock if applicable and/or an

open-end wrench to hold spindle.

2. Install orbital head assembly onto spindle and tighten.

3. Tool will now accept desired pad accessory.

4. Connect machine to power supply and check for proper operation.

Random Orbital Head Assembly Installation Complete.

Storage/Handling:

• Do not rest tool on pad edge - may cause distortion of pad.

• Use of tool rest and/or balancers are recommended.

Model: 51610 Shown

Installation/Pad Change/Storage

(5/8"-11 Spindle) or (M14 x 2 Spindle)

Index Key

No. Part #

Pad Change Procedure:

1. Disconnect tool from power supply.

2. Make sure pad is facing up, use 50679 Open-end Wrench to hold hex

of balancer shaft (hex portion of part located between, 61369/61370

Orbital Head Assembly and backing pad) use 95049 (3/16") Hex

Wrench to remove 96168 Screw and backing pad.

3. Change pad and fasten with one 96168 Screw until tight.

Note: When installing pad remember to use the correct spacer and

washers to ensure a proper fit, see diagram above.

4. Tool will now accept desired pad accessory.

Pad Change Complete.

Power Tool

MAXIMUM TOOL RPM MUST

NOT EXCEED RATING OF 3,200 RPM.

Torque: N•m x 8.85 = In. - lbs.

Description

1 96168

Screw

2 94594

Washer (2)

3 50855

Backing Pad - 8"

4 94595

Spacer

5 61369

Orbital Head Assy. - 5/8"-11

61370

Orbital Head Assy. - M14 x 2

6 90082

Natural Sheep Skin Buff

7 50679

Open-end Wrench (26mm)

8 95049

Hex Wrench (3/16")

All Random Orbital

Assemblies Include

90082 Natural Sheep

Skin Buff.

KEY