DYNACO PAT-4 Montageanleitung - Seite 11

Blättern Sie online oder laden Sie pdf Montageanleitung für Verstärken DYNACO PAT-4 herunter. DYNACO PAT-4 20 Seiten. Power supply
Auch für DYNACO PAT-4: Montageanleitung (16 seiten)

Seite drucken
DYNACO PAT-4 Montageanleitung
inserting it in the adjacent terminal, as marked by the yellow line in Figure 5.
Solder the wire to both terminals.
8. Dress the wires from steps 5-7 off to the right, keeping them together. A second
piece of masking tape around the wires may be helpful.
Prepare the following 4 wires:
1. 4" length of red wire, then strip ¼" of insulation from one end.
2. 4" length of green wire, then strip ¼" of insulation from one end.
3. 8" length of black wire, then strip ¼" of insulation from one end.
4. a second 8" length of black wire, then strip ¼" of insulation from one end.
Refer to Figure 5. Make sure you have oriented the switch as shown in the Figure. The
ALPHA designation, stamped in the metal, must be facing up.
1. Bend a hook in the ¼" uninsulated portion of the red wire, insert it through the
upper TREBLE CENTER hole, and crimp it in place. Solder the wire.
2. Bend a hook in the ¼" uninsulated portion of a black wire, insert it through the
upper 17 hole and crimp it in place. Solder the wire.
3. Dress the wires from steps 1-2 together. A piece of masking tape may help keep
them together, making them easier to identify in final assembly.
4. Bend a hook in the ¼" uninsulated portion of the green wire, insert it through the
lower TREBLE CENTER hole, and crimp it in place. Solder the wire.
5. Bend a hook in the ¼" uninsulated portion of the second black wire, insert it
through the lower 17 hole and crimp it in place. Solder the wire.
6. Dress the wires from steps 4-5 together. A piece of masking tape may help keep
them together, making them easier to identify in final assembly.
Page 11 of 20