DYNACO PAT-4 Montageanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Montageanleitung für Verstärken DYNACO PAT-4 herunter. DYNACO PAT-4 20 Seiten. Power supply
Auch für DYNACO PAT-4: Montageanleitung (16 seiten)

Seite drucken
DYNACO PAT-4 Montageanleitung

Project Overview

Line Amp Distortion Reducer

The project consists of the following steps:
1. Labeling, then desoldering 7 wires from each circuit board.
2. Removing and replacing 1 transistor from each circuit board.
3. Re-attaching the wires to the circuit boards.

Tone Control Switch

The project consists of the following steps:
1. Building the tone control switch assembly
2. Removing the High Filter switch
3. Wiring in the Tone Control Switch
NOTE:
 Section 2: Line Amp Distortion Reducer, applies to the Line Amp Distortion
Reducer.
 Section 3: Tone Control Switch, applies to the Tone Control Switch.
Use the appropriate section for the job at hand.

Important Safety Notes

By purchasing, using, or assembling this kit, you have agreed to hold AkitikA, LLC
harmless for any injuries you may receive in its assembly and/or use. To prevent injuries:
 Wear safety glasses when soldering to prevent eye injuries.
 Always unplug the power before working on the amplifier.
 Large capacitors hold lots of energy for a long time. Before you put your hands
into the amplifier:
o Pull the AC plug!
o Wait 1 full minute for the capacitors to discharge!
 Remove jewelry and rings from your hands and wrists, or anything that might
dangle into the amplifier.
 If working in the amplifier, keep one hand in your pocket, especially if you're
near the power supply or power supply wires. This can prevent serious shocks.
 Build with a buddy nearby. If you've ignored all the previous advice, they can
dial 911 or get you to the hospital.
Page 4 of 20