ADEMCO LYNX Schnellstart-Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Sicherheitssystem ADEMCO LYNX herunter. ADEMCO LYNX 8 Seiten.
Auch für ADEMCO LYNX: Benutzerhandbuch (17 seiten), System Manual (14 seiten)

Seite drucken
ADEMCO LYNX Schnellstart-Handbuch
Keypad Functions (when default programming is used)
Security Functions
Checking system status:
To arm in STAY mode: Press and hold down
To restart exit delay:
STAY
To arm in AWAY mode: Press and hold down
To arm with NO DELAY: Press and hold down
To disarm the system and silence alarms: User Code
To bypass a zone(s): User Code
To turn Chime mode on or off:
Message Center
To record a message:
FUNCTION
To stop recording before end of 20 seconds:
To play back a message:
Volume Control
To adjust message playback/system announcement volume:
To mute system announcements:
To restore announcement sounding:
Other Functions
To set the time and date: User Code
To activate or deactivate devices 1-6:
To activate or deactivate devices 7 & 8: User Code
To program scheduled events: User Code +
To add a User Code: Master Code +
To delete a User Code (except Master Code): Master Code +
To turn Test mode on: User Code
To turn Test mode off: User Code
To use the defined AUX function: Press and hold
(To define the AUX function, refer to the procedure in the Aux Function section of the User Manual.
Note: The 1-button paging feature [field *87] is not enabled with the default programming)
NOTE: The Babysitter Code and Installer Code cannot disarm the system unless it was the
code used to arm the system. In addition, if the system is armed by pressing and
holding the Quick-Arm buttons, neither the Babysitter Code nor the Installer Code can
disarm the system.
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE LIMITATIONS OF THIS SYSTEM
AND WARRANTY INFORMATION.
(high level messages); press
STATUS
STAY
(applies only if system is armed in Stay mode)
AWAY
AWAY
+
+ 2-digit zone number(s)
BYPASS
+
FUNCTION
CHIME
+
RECORD
OFF
+
FUNCTION
PLAY
+
FUNCTION
VOLUME
+
FUNCTION
+
+
FUNCTION
+
FUNCTION
+
FUNCTION
+
user number
CODE
+
TEST
+
OFF
AUX
Page-6
again for secondary messages.
STATUS
(or enter your code +
STAY
(or enter your code +
AWAY )
+
or
STAY
NO DELAY
or enter your user code + the keys shown).
+
See note below.
OFF
+
FUNCTION
VOLUME
+
OFF
+ [
3] or [6]
VOLUME
[63]
or
LIGHTS ON
LIGHTS OFF
+
or
#
LIGHTS ON
LIGHTS OFF
+ [64], then follow procedure in User Manual.
+
User's Code (see note below)
+
user number
CODE
+
key 2 secs (4 beeps)
) See note below.
See note below.
+ [
3] (Up) or [6] (Down)
+
device number
+ d
ev. no.
User Code