HiB 54000 Montageanleitung Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Inneneinrichtung HiB 54000 herunter. HiB 54000 8 Seiten.

Installation

Before installation, ensure the domestic electrical mains supply to which

the cabinet is to be connected is turned off. Before drilling, ensure that

there are no hidden cables or pipes in the wall.

NB. Dusk Cabinets must be installed with a minimum distance of 150mm

(Reflective surfaces may increase requirement) between the infra-

red sensor switch and any adjacent wall or object to ensure correct

It is recommended that this product is installed by two people.

1. Position the cabinet in a suitable location (according to the zonal diagram

on page 3, Fig. 1) ensuring that the mains supply cable is within reach of

the cable connection point of the cabinet.

2. Carefully mark the desired position of the top of the cabinet on the wall

using a soft pencil.

3. Remove the cabinet from the wall and using a spirit level, mark a horizontal

line 35mm below the pencil mark. Hold the mounting bracket in place

with the holes corresponding with the marked line. Ensure the bracket is

central, and mark the position of the holes , see Fig. 2.

4. Before drilling, ensure there are no hidden cables or pipes behind

the mounting points. Drill the required holes in the marked positions.

If drilling through tile, use a ceramic drill bit. Insert the wall plugs level

with the surface of the wall. If fitting to a tiled surface, wall plugs should

be inserted below the tile surface to avoid cracking. NB. For plasterboard

walls, specialist fixings should be purchased, available from any DIY or

hardware store. Fix the bracket to the wall using the screws provided.

5. Temporarily hang the cabinet on the top bracket, see Fig. 3, and mark the

position of the bottom mounting hole on the wall using a soft pencil, then

remove the cabinet from the wall.

6. Drill a hole in the wall where you have marked with the soft pencil. Insert a

wall plug level with the surface of the wall as per step 4.

7. Ensure the domestic electrical mains supply to which the product

is being connected is turned off. Connect the domestic mains supply

according to the wiring diagram on page 3.

8. When the product is wired correctly, hang the cabinet on the top bracket,

see Fig. 3, and secure the cabinet with a screw through the bottom

mounting hole, see Fig. 4. Take care not to overtighten the screw against

the backboard, the screw is not load bearing - it is only intended to

prevent the cabinet from moving away from the wall.

9. When the cabinet is correctly fitted, adjust the shelf support brackets to

your desired height ensuring the matching brackets are level. This is done

by slightly loosening the screw, do not remove the screw completely, see

Fig. 5. Once in position tighten screw to secure the bracket and put the

glass shelf into the shelf support bracket.

operation of the sensor.