GREAT PLAINS PA-120DEF Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Water Pump GREAT PLAINS PA-120DEF herunter. GREAT PLAINS PA-120DEF 16 Seiten. Plastic utility pump

Seite drucken

•

Do not run the pump more than necessary without

flow. "Dry running" can cause overheating and pump

damage.

•

To avoid personal injury, turn the pump off and

disconnect from power before repair or service.

•

For your protection, thoroughly flush the pump before

cleaning or repair.

When you receive your pump, examine it for visible

damage. If any items are damaged or missing, please

contact your distributor.

INSTALLATION

For proper installation, your pump requires a hose, nozzle

and suction pipe. Kits are available from the factory and

are listed as accessories on the Illustrated Parts List.

Used pumps must be flushed and cleaned before

installation as outlined in the Maintenance Section.

To prevent leaks, seal all connecting threads with 3 to 4

turns of thread tape during installation.

Before installing the pump, install the suction pipe into

bung adapter on the pump. Tighten the suction pipe into

the bottom of the bung adapter until only three threads

are visible.

Installing Pump

The pump has a 2-inch NPS bung adapter with gaskets

installed at the inlet end.

After installing the suction pipe into the bung adapter,

insert the suction pipe into the tank opening and tighten

the pump securely. Make sure the bung adapter threads

are not cross-threaded. (Figure 1)

Install Hose and Nozzle

If installing accessories such as meters or filters, do

so before installing the hose and nozzle. Follow the

manufacturer's instructions.

CAUTION

Make sure any hose and nozzle used are compatible

with DEF.

After sealing threads, hand-tighten the hose into the

outlet until snug. Hand-tighten the nozzle to the hose.

Using fluids other than those for which the pump was

designed could lead to serious personal injury and void

the warranty.

The pump is approved for Diesel Exhaust Fluid only.

Do not use with gasoline, diesel, other flammable

fluids, or micro-encapsulated fluids.

When handling fluids, always wear protective

clothing such as goggles, gloves and respirators,

as instructed by the fluid manufacturer.

Clean any spills from the system exterior as they occur,

following fluid manufacturer's instructions.

Before Each Use

1. Keep pump exterior clean to help identify leaks.

Before each use, inspect for leaks around seals or

connections.

2. Check for leaks under the pump housing. A small

drain hole relieves any fluid which bypasses the

motor shaft seal. (Figure 2) If any leakage is found

here, replace the motor shaft seal using instructions

in the Repair Section.

Figure 1

3. Make sure hoses are in good condition and

connections are tight.

4. Make sure the work area is dry.

Electrical Connections

PA-120DEF:

This pump is designed for use with GFCI protected, 115-

volt power. Do not attempt to install or operate the pump

with 12-volt, 24-volt or 230-volt power.

Use only three-prong, grounded connectors. Do not use

two-prong connectors or adapters. Inspect power cords

regularly and replace if signs of wear are evident.

OPERATION

WARNING

Figure 2