HiB Novum NF02SBTW50 Series Montageanleitung Handbuch - Seite 13

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Inneneinrichtung HiB Novum NF02SBTW50 Series herunter. HiB Novum NF02SBTW50 Series 16 Seiten.

Seite drucken

Drawer Installation and Adjustment

HiB recommends fixing handles to the drawer box prior to installing the

drawers. See the Handle Installation section below.

2. Align the drawer onto the runners ensuring the rear hooks are located in the

holes on the rear of the drawer box, see Fig. 16.

3. Ensure that the locator pin on the front of the runner, see Fig. 17, is aligned

with the hole predrilled on the base of the drawer.

4. Push the drawer shut to check the alignment of the drawer. Adjust using the

adjustment wheel on the drawer runner, see Fig. 17.

5. If additional adjustment is required locate the central screw behind the drawer

front in the drawer box. Loosen the screw, adjust the drawer front into position

and then tighten the screw, see Fig. 18.

6. Push the drawer shut to finish.

Handle Installation

Profile Handle

Pre-drilled pilot holes have not been supplied for this handle.

Plan the position of the handles on the doors.

2. Mark the hole centres and pre-drill pilot holes using a suitable drill-bit.

3. Using the screws provided, secure the handle into place. Do not over-tighten.

Bar Handle & Holton Handles

Locate the pre-drilled pilot holes on the back face of the door/drawer.

2. Clamp a clean piece of MDF behind the drill location of the door prior to

drilling.

3. Drill holes required.

4. Using the screws provided, secure the handles into place. Do not over-

tighten.

hib.co.uk