GREAT PLANES Douglas DC-3 Gebrauchsanweisung - Seite 14

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Spielzeug GREAT PLANES Douglas DC-3 herunter. GREAT PLANES Douglas DC-3 20 Seiten.

7. Insert the elevator joiner into place and hold it there

while sliding the stab into the slots. Do not glue anything into

place yet. We are test fitting everything first to make sure

that it fits correctly.

8. Slide the elevators into place using the joiner and

hinges. Everything should fit, match-up properly and move

freely. When you are satisfied with the alignments and fits,

remove the elevators and double check that the alignment of

the stab is correct. Glue the stab into place by wicking thin

CA into the joint between the stab and fuselage. Fill any

gaps with medium CA.

9. Use thick CA or epoxy to glue the joiner into the

elevators, but be careful not to get any excess glue on the

stab or on the fuselage. When you have the elevators in place

with no gaps between the stab and elevators, place six drops

of thin CA on both sides of each hinge and let it cure. Do not

use any accelerator while gluing the hinges into place.

10. Mount a nylon control horn on the elevator and the

rudder with two 2mm x 16mm Phillips head screws. Drill

5/64" [2mm] holes for the screws. Make sure the control

horns are aligned with the pushrods.

Install the Radio

1. Place the two Velcro

battery tray and test-fit the battery as shown in the above photo.

Review the next two steps before proceeding.

2. Put the piece of hatch material inside the fuselage and

trace the hatch opening on the hatch. Cut the battery hatch

on the cut-lines you have drawn. Do this carefully to prevent

the hatch from chipping. Curved tip scissors work well for this.

battery straps into the forward