ActiveAid 285 Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Wheelchair ActiveAid 285 herunter. ActiveAid 285 13 Seiten.

Usage

(cont.)

Casters

Locking casters: To lock casters (option), push down on the front of the caster brake lever. To release caster

brake, push down on the rear of the caster brake.

Removing Casters: Loosen then remove the self-locking nut and machine screw that are in the chair frame

where the casters will be inserted. Insert caster so that it is flush with the frame. Re-insert the screw through the

holes in the chair frame and caster stem. Note: Screw head should be to the outside of the frame and the nut to

the inside. Hand start the nut onto the end of the screw Use a wrench and hex key to tighten the casters into

place. Repeat for second caster.

Wheels

Wheel Locks

To engage the wheel lock, push forward on the lever, to unlock pull back on the lever.

Note: If the wheel moves while wheel lock is engaged, the assembly needs to be moved slightly closer to

the wheel.

Belts

Hook and Loop Fasteners

Pull the belt strips apart to separate them. Adjust the strips to the proper position. Press the belt strips together

to connect them.

Snap Fit Buckle

To unbuckle, depress the two spring arms on the male end and pull/slide to separate it from the female receiver.

To buckle, insert the male end into the female receiver until the spring arms secure. Listen for clicking sound to

indicate it is secure. Pull strap thru male portion of buckle to tighten.

Abductor/Deflector

Slide deflector into the front opening of the seat.

Swing Away Adjustable Laterals

To swing the lateral back out of the way, depress the button, pull lateral back around behind the back. To make

width adjustments, loosen screws, slide lateral left or right in bracket to desired position, tighten screw.

Arm-Mounted Hip Guides

To adjust forward/rear position, slightly loosen front/rear knob and slide assembly forward/backward to desired

position, tighten knobs. To adjust width, slightly loosen middle two knobs, push/pull assembly in/out to desired

position, tighten knobs.

Check all fasteners (snap buttons, screws, nuts, bolts, clips, pull pins, handles, etc.) for tightness and make sure

they are secure.