Dynacord Madras M 212 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Dynacord Madras M 212 herunter. Dynacord Madras M 212 16 Seiten. Powered system 2 x12"/2" 600 watts amplifier output power high efficiency power tracking supply

Seite drucken

CONTROLS

LIMIT brief blinking indicates that the power amplifier is operated

at its limits. Short-term blinking is uncritical, because the integrated

limiter compensates minor distortion. Constant lighting of the LED

indicates that the sound is negatively affected. Reducing the output

volume is strongly recommended.

SIGNAL indicates the presence of an input signal.

THERMAL lights, when the power amp's output power is reduced to

prevent thermal overload.

PROTECTION lights, when one of the power amp's comprehensive

protections against e.g. thermal overload, HF or DC at the output,

and Back-EMF has been activated. The speaker outputs are

deactivated and the input gain is reduced when in Protect Mode, to

protect the power amplifier from damage.

The PROTECT LED lights for approximately 2 seconds during

power-on operation. This is normal, indicating that all protections are

working.

POWER-switch

Mains switch for powering the appliance on or off. With the power

amplifier being switched on, the mains switch is backlit. If, after

switching the power on, the switch is not backlit, please first check

whether the mains cord is correctly connected. In case the cord

has been connected correctly and the switch still fails to light (no

function), please contact your specialist dealer.

MAINS FUSE

Under normal circumstance the mains fuse only blows in case of

failure. Always use an identical type with the same current, voltage

and blow characteristics when replacing the mains fuse. If the mains

fuse blows more often, please contact your specialist dealer.

MAINS IN

Mains connector is carried out as PowerCon-type socket. A fitting

mains cord (5m) with PowerCon-type plug is supplied.

MAINS OUT

This PowerCon mains out socket allows the connection of additional

MADRAS cabinets, e.g. M212 or M18, using special cords (PC150 or

PC800).

To prevent mains n etwork overload, connecting more than three

MADRAS cabinets to a single mains outlet (10A-16A) is not

recommended.