GREAT PLANES HeadWind "B" Gebrauchsanweisung - Seite 11

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Spielzeug GREAT PLANES HeadWind "B" herunter. GREAT PLANES HeadWind "B" 16 Seiten. Park flyers series

Seite drucken

5. Re-mount the gear box and motor to the mount.

Complete Final Radio Installation

The battery and receiver mounting are used to adjust the

center of gravity (CG). We recommend using the Great Planes

Sanyo

8 Cell 350 2/3AA NiCd to power your Headwind B. For

now, temporarily position the battery and receiver in the radio

compartment as shown, but do not secure in place. When

setting the CG (below), adjust positioning as needed,

remembering to also reposition the Velcro

mounting to properly hold them in place.

GET THE MODEL READY TO FLY

Check the Control Directions

1. Turn on the transmitter and receiver and center the

trims. If necessary, remove the servo arms from the servos

and reposition them so they are centered. Reinstall the

screws that hold on the servo arms.

2. With the transmitter and receiver still on, check all the

control surfaces to see if they are centered. If necessary,

adjust the pushrods to center the control surfaces.

correct direction as shown in the diagram. If any of the

controls respond in the wrong direction, use the servo

reversing in the transmitter to reverse the servos connected

to those controls. Be certain the control surfaces have

remained centered. Adjust if necessary.

Use a Great Planes AccuThrow

measure and set the control throw of each control surface as

indicated in the chart that follows. NOTE: The throws are

measured at the widest part of the elevator and rudder.

and rubber band

These are the recommended control surface throws:

IMPORTANT: The Headwind B has been extensively

flown and tested to arrive at the throws at which it flies

best. Flying your model at these throws will provide you

with the greatest chance for successful first flights. If, after

you have become accustomed to the way the Headwind B

flies, you would like to change the throws to suit your

taste, that is fine. However, too much control throw could

make the model difficult to control, so remember, "more is

not always better."

3-CHANNEL RADIO SETUP

(STANDARD MODE 2)

ELEVATOR MOVES UP

4-CHANNEL

TRANSMITTER

RUDDER MOVES RIGHT

4-CHANNEL

TRANSMITTER

MOTOR TURNS

4-CHANNEL

TRANSMITTER

3. Make certain that the control surfaces respond in the

Set the Control Throws

ELEVATOR:

RUDDER:

™

(or a ruler) to accurately

1/2" [13mm] up

1/2" [13mm] down

1" [25mm] right

1" [25mm] left