GREAT PLANES Power Pod Montageanleitung - Seite 3

Blättern Sie online oder laden Sie pdf Montageanleitung für Spielzeug GREAT PLANES Power Pod herunter. GREAT PLANES Power Pod 4 Seiten.

❑

11. Attach the ON/OFF switch to the frame.

❑

12. If using an .049 glow engine, glue the two firewall

supports to the main frame. Glue the firewall assembly together

and then to the main frame. Make sure the firewall points are

square to the frame.

❑

13. Center the engine onto the firewall so the engine head is

straight up. Use 2-56 bolts with locknuts (not included) to secure

the engine.

❑

14. Trim the mating edges, and test fit the shroud halves

together. The edges should meet with minimal gaps. The bottom

edges will be trimmed off later. Cut a circle for the toggle switch

and the engine head (if needed). If you use the bases that have

the tabs for rubber bands, trim the shroud around them.

❑

15. When satisfied with the fit, drill 1/16" holes through the

shroud and into the side braces. Attach the shroud using four

#4 x 3/8" screws.

❑

16. Use the white decal strips to cover the seam between the

edges of the shroud halves. Start each piece of tape at the top

of the shroud and work towards the bottom. Cut off any excess.

❑

17. Trim off the bottom edge of the shroud so it is even with

the bottom of the base.

Mounting the Power Pod to your Model:

Method A:

Mounting on the Great Planes Spirit with two-piece wing.

❑

1. Position the Power Pod onto the wing root and insert the

wing joiner. Glue the plywood rib spacers to the root of one of

the wing panels. If needed, carefully trim away balsa to allow

additional clearance for the servo and battery wires.