GREAT PLANES Riot 3D Gebrauchsanweisung - Seite 8

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Spielzeug GREAT PLANES Riot 3D herunter. GREAT PLANES Riot 3D 20 Seiten.

❏

3. Center the bottom wing in the wing saddle area as

shown using the same measuring technique as the stabilizer.

It may assist you to mark the centerline on the fuselage and

bottom wing with a felt-tip pen. Mark on the wing where it

meets the fuselage. Trim the covering inside the marks, and

then, glue the wing in place using medium CA. Be very

careful not to cut into the balsa.

❏

4. Locate the two wing struts and center cabane. There

are slots in the top of the bottom wing, and the bottom of the

top wing for these wing struts to slide into. Carefully remove

the covering from these slots using a sharp hobby knife.

❏

5. Test fit the wing struts and center cabane as shown in

the photos above. Glue the wing struts in place as shown

using medium CA. Note the direction of the wing struts.

Insure the struts are parallel to the fuse.

❏

6. Test fit the the top wing on the struts and center

cabane. Glue the top wing to the wing struts using medium

CA. Check that the top wing is parallel to the bottom wing.