GREAT PLANES Seawind EP Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Spielzeug GREAT PLANES Seawind EP herunter. GREAT PLANES Seawind EP 20 Seiten.

ASSEMBLY

Mount the Motor & Cowl

❏

1. Fit together the assembly/transport stand. Note that the

arrows on the sides point toward the front cradle which is the

one that is shortest. Use foam-safe CA, epoxy or white glue

to glue it together.

❏

2. Test ﬁ t the model in the stand. If necessary, use a hobby

knife to trim the short cradle where shown to ﬁ t the fuse.

❏

3. Use a 1.5mm Allen wrench to loosen the set screw in

the collar on the front of the motor (not included) and remove

the collar. Also remove the mounting plate, but leave the prop

saver screws in place because they hold in the drive shaft.

❏

4. Connect the wires on the motor to the wires in the fuse.

Mount the motor with the three 3mm x 6mm Phillips screws that

came with this kit and a drop of threadlocker on the threads.

❏

5. Temporarily mount the prop adapter and the propeller

to the motor shaft. Use an 8mm wrench to tighten the prop

nut while holding the collet with a 10mm wrench to lock the

prop adapter onto the shaft.

❏

6. Loosen the prop nut and remove the prop and washer.

The collet should remain locked to the motor shaft. If the collet

does not remain locked, use a small drop of CA on the collet

to hold it to the propeller shaft. Then lock it down again.

❏

7. Insert a pin into the motor pod 1/2" [13mm] behind the

middle of the wood block for the top cowl mounting screw.

❏

8. Insert two more pins into the engine pod 1/2" [13mm]

behind the middle of the other two cowl mounting blocks

around the bottom of the motor pod.

❏

9. Fit the cowl to the pod. Mount the propeller with the

prop washer and prop nut.