GREAT PLANES Silhouette Gebrauchsanweisung - Seite 5

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Spielzeug GREAT PLANES Silhouette herunter. GREAT PLANES Silhouette 16 Seiten.

the wing in position. Use a square to check that the wing is

perpendicular to the fuselage. Since the fuselage is tapered,

make sure the gap is the same on both sides.

❏

5. With the plane setting on your building table, apply a

bead of foam-safe thin CA along the top joint between the

fuselage and the wing. Once the CA has cured (do not use

CA activator yet), turn the plane over and again apply a bead

of foam-safe thin CA along the bottom joint.

❏

6. Once the foam-safe thin CA has cured, apply a bead of

foam-safe medium CA along the joint where there is a gap

between the fuselage and the wing. Now use foam-safe CA

activator on the glue joints.

❏

7. Bevel the ends of the two 3mm x 6mm x 290mm wing

reinforcement strips. Glue the strips to the underside of the

wing and fuselage joint.

INSTALL THE STABILIZER

❏

1. Carefully insert the elevator in the stabilizer slot. Make

sure the counter balances are facing forward and the correct

side is up.

❏

2. Insert the stab in the stab slot and center it side-to-side.

Measure the distance from the tip of the stab to the center

of the fuselage. Adjust the position of the stab until they are

equal. Also check that the stab is parallel with the wing when

viewed from the aft end. Use thin foam-safe CA to glue the

stab to the fuselage.

❏

3. Cut two 170mm long pieces of clear tape for the elevator

hinges. Apply one of the pieces of tape to the leading edge of

the left elevator half so that half of the tape is on the elevator.

Center the elevator on the stabilizer and with the elevator

hanging down, press the hinge tape onto the stabilizer.

Repeat the process on the right side.

❏

4. Insert one of the plywood control horns in the slot in the

bottom of the elevator. Glue the control horn in the elevator

with foam-safe thin CA.