GREAT PLANES Slow Poke Sport .40 Gebrauchsanweisung - Seite 8
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Spielzeug GREAT PLANES Slow Poke Sport .40 herunter. GREAT PLANES Slow Poke Sport .40 20 Seiten. Arf plane
Seite drucken
Install the Ailerons
1. The ailerons are taped in place to the wing. Remove
them from the wing.
2. Begin with the right aileron. On the leading edge of
the aileron you will find three hinge slots pre-cut into it. You
will also find three hinge slots cut into wing trailing edge.
Insert your hobby knife into the hinge slots to be sure there
is enough clearance for the hinges.
3. Locate the 2" x 9" [51 x 229mm] hinge material.
Cut fifteen 1" x 3/4" [25 x 19mm] hinges from the strip as
shown in the above sketch. Clip the corners of each one as
shown. This will allow easier installation of the hinges.
4. Insert a T-pin into the center of three hinges. This
will assure that the hinge material remains centered
between the aileron and the wing. Install the hinges into the
three hinge slots in the leading edge of the aileron.
5. Once the hinges are fit to the aileron, insert the
opposite end of the hinges into the trailing edge of the wing.
Make sure that the aileron is centered in the aileron opening
in the wing. Remove the T-pins.
each of the hinges. Allow the glue to cure and do not use
any type of CA accelerator to speed up the curing process
as this will make the hinge brittle.
1"
1"
3/4"
servo extensions. The extensions must be compatible with your
radio system and must be purchased separately. Plug the 6"
extension to the servo. Secure the connection with tape to
assure that the connectors do not accidentally come unplugged.
there is a piece of string taped to the rib. Remove the string
from the rib. Tie the string to the end of the servo wires.
of the servo lead to the center section of the wing to prevent
it from accidentally falling back into the wing. You may wish
to trim away the excess covering material from the hole
where the servo lead exits the wing.
8
6. Apply 6 drops of thin CA to the top and bottom of
7. Repeat these steps for the left wing and aileron.
Install the Aileron Servos
1. The installation of the aileron servos requires two 6"
2. On the bottom of the right wing in the servo opening
3. Pull the servo lead through the wing. Tape the end