HiB Demista D2 Montageanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Montageanleitung für Körperpflegeprodukte HiB Demista D2 herunter. HiB Demista D2 2 Seiten.

Installation

Before drilling ensure that there are no hidden cables or pipes in the wall.

Cut out the recess in the wall to house the terminal moulding so that Demista is flush when fitted.

2. Mark back of mirror appropriately as to not damage the mirror, to indicate where Demista is to be fitted.

3. Peel protective release paper from front of Demista.

4. Position one edge of Demista onto back of mirror holding opposite edge away from mirror.

5. Apply pressure evenly over full pad as Demista is gradually lowered on to mirror back.

6. Continue until Demista is completely flat of mirror back with no air bubbles.

7. Fix Demista mirror assembly to wall.

8. If mirror/Demista assembly is to be bonded to the wall, the adhesive should be applied over the complete area to

ensure that the mirror is securely held.

NOTE: White patches that might appear beneath the film are 'de-lamination'. This is caused by the ingress of air between

the insulation and element as a result of handling and neither affects the operation of Demista nor is it detrimental in any

way.

Aftercare

In the unlikely event that this product should fail please contact the retailer from which the item was purchased.

WEEE compliance

Must not be mixed with

general household waste

FI#01 037 R210730

Fitting Instructions

Demista Pads

Ver No.

1.0 July 2021