GREAT PLANES Yard Stik Gebrauchsanweisung - Seite 8

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Spielzeug GREAT PLANES Yard Stik herunter. GREAT PLANES Yard Stik 16 Seiten.

6. Mount the servos to the battery holder as shown using

the screws and rubber grommets that came with the servos.

7. Make an approximately 1/2" [13mm] deep V-bend in

both pushrod wires as shown (the precise location and

depth of the bends isn't critical). Guide the pushrods through

the tail wire mount and the aft wing mount. Then, if

necessary, slightly enlarge the holes in the servo arms to

accommodate the wires and mount the wires to the servo

arms. Note: The elevator pushrod (on the right side of the

model–not visible in the photograph) goes in the servo arm

on the top of the servo.

8. Center the servo arms on the servos. Make an L-bend

in the end of both wires where they fit into the control horns

so the rudder and elevator will be centered. Cut off any

excess wire so approximately 1/4" [6mm] of the "L" remains.

Connect the pushrods to the second-from-the-outer holes in

the control horns. Later, after the elevator and rudder have

been centered and the control throws have been set,

retainers will be installed on the wires so they cannot come

out of the control horns.

9. Fit the tail wire into the slot in the bottom of the tail

wire mount. Use a few drops of thin CA followed by a few

drops of medium CA to glue the tail wire into the mount and

to glue the mount onto the fuselage boom.

10. Use medium-grit sandpaper to roughen the ends of the

landing gear wire where the retainers go. Slip on the wheels,

and then glue on the retainers with a drop of medium CA. Be

careful not to inadvertently get any glue on the wheels.

11. Bend the tail wire as necessary to raise the elevator

approximately 1/2" [13mm] from the ground when it is level.