GREAT PLANES ElectriFly PEAK 400 Anleitung Handbuch - Seite 8
Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Batterieladegerät GREAT PLANES ElectriFly PEAK 400 herunter. GREAT PLANES ElectriFly PEAK 400 13 Seiten.
Seite drucken
charged at the 500mA setting. This charger is not
recommended for cells smaller than "AAA". Connect the
battery to the charger's "OUTPUT" connector as explained
above. The yellow "Power" LED will be lit indicating power is
supplied to the charger, and the red/green LEDs will
alternately blink - this is normal. Push the charger's "START"
pushbutton in the sequence listed below to initiate the quick
charge process:
a. NiCd BATTERIES: press the "START" pushbutton ONCE
to charge NiCd batteries. The green LED below the NiCd
label will be on solid, thus indicating that the peak detection
quick charge of NiCd batteries is in progress.
b. NiMH BATTERIES: press the "START" pushbutton and hold
for approx. 3 seconds to charge NiMH batteries.The red LED
below the NiMH label will be on solid, thus indicating that the
peak detection quick charge of NiMH batteries is in progress.
If it is necessary or desirable to stop the charge process after
it has already begun, simply re-press the "START" button
which will cause the LEDs (red and green) to resume blinking
alternately as mentioned above, indicating the quick charge
process has been halted.
WARNING! It is normal for batteries to become warm
during charge. Disconnect batteries IMMEDIATELY if they
become hot at any time! Extra caution must be observed
with NiMH batteries as any heating will reduce the
lifespan of the battery. In such case, it may be necessary
to reduce the fast charge current to lower the possibility
of heating. Never attempt to charge batteries at excessive
rates, as permanent damage could result.