HiB Solstice 80-BLK Montageanleitung Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Körperpflegeprodukte HiB Solstice 80-BLK herunter. HiB Solstice 80-BLK 8 Seiten.

Installation

It is recommended that this product is installed by two people.

Position the mirror in a suitable location (according to the zonal diagram - Fig.

1), ensuring that the domestic electrical mains supply is within reach of the

cable connection point of the product.

2. Carefully mark the position of the mirror using a soft pencil ensuring it is level.

Remove the mirror and mark the mounting points, see Fig. 2. Please ensure

that all marked mounting points accurately match up with the fixing

points on the mirror.

3. Using a suitable drill bit, drill holes in the marked positions to a suitable

depth. If drilling through tile, use a ceramic drillbit.

4. Insert wall plugs level with the surface of the wall. If fitting to a tiled surface,

wall plugs should be inserted below the tile surface to avoid cracking. NB. For

plasterboard walls, specialist fixings should be purchased, available from any

DIY or hardware store.

5. Screw supplied fixings into wall plugs.

6. Attach the decorative strap to the side of the mirror frame using the bolts

provided, see Fig. 3. Please note this is not intended to be used as the

main weight bearing fixing.

7. With the mirror in position, carefully mark the position of the strap support

hook using a soft pencil and ensuring the strap is taut and the hook is central

to the mirror, see Fig. 4.

8. Remove the mirror from the wall.

9. Again, using a suitable drill bit, drill holes in the marked position to a suitable

depth and insert wall plugs.

10. Position the strap support hook and fix in place with the supplied fixings.

11. Ensure the domestic electrical mains supply to which the mirror is being

connected is turned off. Connect the domestic mains supply to the terminal

box according to the wiring diagram, see page 3.

12. Hang the mirror into position and locate the strap over the hanging support

hook.

13. Remove the adhesive pad cover from the support hook finishing cap and

apply to the support hook.

14. Switch the domestic electrical mains supply for the mirror back on.