GREAT PLANES MASTER CADDY Montageanleitung Handbuch - Seite 12
Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Messgeräte GREAT PLANES MASTER CADDY herunter. GREAT PLANES MASTER CADDY 15 Seiten. With auxiliary power station
Seite drucken
C1 10. Slide the bottom drawerin over the top of the die
cutsheet. Sand one end of each 1/4" sq. drawer support
to a slight taper as
shown in the sketch on
the right. Apply glue
to one side of each
support and glue it to the upright, being very careful not
to glue the support to the drawer. The supports should
rest on top of the drawer sides until the glue has cured.
Remove the bottom drawer and remove the die cut sheet.
Replace the bottom drawer.
GLUE THIS SIDE~
C] 11. Slide the top drawer into its slot and use the 1/8"
scraps used earlier to center the drawer.
Test fit the
drawer front in place and sandif necessary to make it fit
nicely.
When satisfied with the fit, glue it in place
following the same sequence you used for the bottom
drawer.
C] 12. If you are going to use a round plastic fuel con-
12
tainer, glue the plywood gussets in place approximately
3" above the bottom.
If you are using a metal fuel
container, do not use the gussets.
[] 13. Remove both drawers and install the wooden
knobs using the #10 x 5/8" screws. Do not use any glue
on the knobs until after the MASTER CADDY has been
finished.
CRADLES
C] 1. Punch out the remaining sets of cradles from the
1/8" die cut sheets.
You should have four ''sets'' of
these. It takes two sets (as shown above) to assemble one
cradle.
C] 2. Thetwosets of cradles shown in step #1 should
be laminated to make one cradle as shown at the top of the
next page.
The two small doublers should be glued
together and then they should be glued to the cradle half
with the hole in it.