GREAT PLANES MASTER CADDY Montageanleitung Handbuch - Seite 9
Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Messgeräte GREAT PLANES MASTER CADDY herunter. GREAT PLANES MASTER CADDY 15 Seiten. With auxiliary power station
Seite drucken
CL) 4. Make a mark on the inside of each upright 6"
from the bottom. Temporarily position the shelf in place
at these marks and then check to make sure your battery
will fit in this space.
You can adjust the height as
necessary but do not put the shelf above the bottom of the
top hole in upright B without making a clearance slot in
the shelf for the screw to pass. When satisfied with the
position of the shelf, securely glue it in place. Glue the
dowel handle in place.
(J 5.
Glue one piece of the tapered basswood strip to
the edge of the APS bottom as shown in the photo. The
slanted edge of the strip goes toward the front edge of the
bottom.
The tapered strip should be centered between the side
edges and lined up along top edge of the APS front. It
does not matter which end of the APS front is the top
since the cutout is centered, but you should use the best
looking side for the face.
O 7. Onanice flat work surface, install the APS in
place on the caddy and make sure it is seated properly.
Glue the APS front to the tapered strip and the upright
so the bottom edge of the APS front is resting on the
work surface.
CO 8. Whenthe APS is removed it should look like the
photo above.
C 6. Glue the slanted face of the remaining tapered
basswood strip to the top back edge of the APS front.
CO 9. Glue the six 3/8" x 3/8'' x 1" basswood blocks
in place as shown in the photo. IMPORTANT - The