HiB 32300 Anleitungen zur Befestigung - Seite 2

Blättern Sie online oder laden Sie pdf Anleitungen zur Befestigung für Fan HiB 32300 herunter. HiB 32300 2 Seiten. Ceiling mounted ventilation
Auch für HiB 32300: Schnellstart-Handbuch (4 seiten)

Seite drucken

Position the Fan on the Ceiling

1) Choose a suitable position for your fan

according to Figure 1 opposite. Use a

cable ﬁ nder to check if there are any

buried cables or pipes in the ceiling.

Ceiling mounted ventilation should

be ducted through the roof space, by

ducting to an external sofﬁ t under the

eaves or grille in the slope of your roof.

NB: Ducting installed between a ﬂ oor

and ceiling can only run between joists,

not across them.

2) Mark the position of the vent fascia with

a pencil in a suitable position on the

ceiling, making sure that it is between

the joists.

3) Drill a 9mm hole through the ceiling

anywhere along the edge of the pencil

line. Now cut out the hole with a pad

saw.

4) Hold the vent fascia against the ceiling

and mark the position of the ﬁ xing

holes. Fix the unit in place using suitable

heavy duty plasterboard ﬁ xings (not

supplied).

5) Attach ﬂ exible ducting with the metal

hose clamps. Ensure that the ducting

has a smooth ﬂ ow towards the external

grille to minimise air resistance. Follow

a similar procedure for the outside

wall grille.

6) Install the Turbo Inline fan within the

loft or ceiling space. A mounting foot is

supplied to assist.

7) Connect the ﬂ exible ducting to both

sides of the Inline fan with the metal

hose clamps.

Electrical Connection

1 casing

2 retaining clip for power wires

3 holes for power wires

4 terminal block

1) Ensure the domestic electrical mains

supply to which the fan is being

connected is turned off. This product

is designed to be connected to an on/

off switch outside the bathroom, or to a

ceiling mounted pull cord switch.

2) Remove the protecting grille and lamp.

This product is SELV and the mains

power should be connected to the

transformer supplied. See diagram

below.

3) Connect the electrical wiring to the motor according to the diagram below.

4) Fix the fan to the ceiling using 4 screws.

5) Replace the cover and protective grille.

Figure 1

60cm

zone

All installations must comply with guidelines which are based on a zonal concept.

The diagram above illustrates this concept and must be followed to ensure the safe

installation of bathroom ventilation. These regulations apply to domestic installations

only. Installations must be made in accordance with the current IEE wiring regulations

and relevant building regulations. HiB recommends that all electrical bathroom products

should only be ﬁ tted by a suitably qualiﬁ ed, Part P registered electrician.

This product is IPX4 Rated, and suitable for installation in Zone 2 and Outside Zones.

220-240 V

60cm

zone

outside

zone

60cm

zone

radius

zone