Automated Logic InterOP8500 Technische Anweisungen - Seite 6

Blättern Sie online oder laden Sie pdf Technische Anweisungen für Kontrolleinheit Automated Logic InterOP8500 herunter. Automated Logic InterOP8500 20 Seiten.

Seite drucken

Johnson Controls

Panel

InterOp-8500

Edge Connectors

Johnson Field

Termination Board

(FTB-102)

to External

Power Supply

Figure 5. InterOp8500/RPA-105 and LPS-105 mounted in Johnson Controls panel

Using the ALC Power Supply

The PWRSUP8500 power supply replaces both

the Johnson Controls LPS-105 and Johnson

RPA-105. The PWRSUP8500 is designed to fit

into the previous power supply's mounting

bracket and power the InterOP8500. The

PWRSUP8500 does not require any adaptor

cables. It connects directly to the

InterOp8500's power connector.

CAUTION

CAUTION The PWRSUP8500 module is a

CAUTION

120VAC device. Take appropriate isolation

measures when mounting a PWRSUP8500.

1. Turn the power switches off on the

InterOP8500 and the Johnson Controls

panel.

2. Unplug the LPS-105 from the power outlet

(see Figure 5).

3. Remove the power cable from the

InterOP8500 power connector.

Revised 7/10/01 • InterOP8500

Plastic Retainers

OFF

J20

J23

4. Take out the mounting screw from the

face of the LPS-105 and remove the LPS-

105 from the Johnson Controls panel.

5. Take out the mounting screw from the

back of the RPA-105 and remove the RPA-

105 from the Johnson Controls panel.

6. Place the PWRSUP8500 in the same

brackets that the RPA-105 was in. Make

sure the edges of the PWRSUP8500 are in

the slots.

7. Replace the mounting screw in the back

of the PWRSUP8500 (see Figure 3 on page

5).

8. Connect the power cable of the

PWRSUP8500 to the InterOP8500 power

connector and plug the PWRSUP8500 into

the power outlet.

9. After verifying that you have +5V on the

red and +12V on the blue, referenced to

the Gnd (black), turn the InterOp8500

power switch on.

LPS-105

Panel Power

Switch

Grounding Wire

(green)

RPA-105

(side-mounted)

Power Adapter

Cable