Automated Logic R683 Technische Anweisungen - Seite 13

Blättern Sie online oder laden Sie pdf Technische Anweisungen für Kontrolleinheit Automated Logic R683 herunter. Automated Logic R683 16 Seiten. Rlm v4.7

Seite drucken

The "Run" LED will begin its normal operation

(rapid flashing).

NOTE: The "Error" LED will stay OFF unless an error is

encountered or memory has not been transferred, in which

case it will stay ON.

If the module is not responding and the LEDs do not

appear to be going through the appropriate power-up

sequence, call ALC Technical Support for assistance.

Transferring Memory

Use the following procedure to transfer memory to the

R683 module. If any problems occur during this

procedure, contact Technical Support.

Log into SuperVision, SuperVision for Windows, or

Vision+ using a Workstation or portable computer

that is directly connected, modem connected, or

connected directly on the ALC network. When

transferring to multiple modules, a direct network

connection will yield the fastest transfer time.

Press the [ESC] key and type:

MO ,,(module no.), 15

NOTE: The module number is the same as the

module's address. If the module is on-line and

communicating, this command will bring up the

Modstat page.

Look at the Modstat page and verify that the module

type and number agrees with the module to be

transferred.

Transfer memory to this module.

For SuperVision 2.6 and earlier, click on the

Download icon and choose the Memory- This

Module option. Click OK.

When the memory transfer is finished, obtain the

Modstat page. Check the screen display's FB List to

verify that the FBs you intended to transfer are in the

module.

Rev. (30-JAN-98) • RLM v4.7

Fuses

The R683 module is protected by two (2) 0.5 A pico fuses

on the CMnet (+) and (-) terminals and one (1) 3.0 A pico

fuse on the 24 VAC power terminal. See Figure 17 for the

fuse locations.

A blown fuse could indicate incorrect wiring (such as

reversed polarity) if the fuse is blown during installation.

In most cases, a blown fuse indicates a power surge was

received by the board.

An RMA is not necessary to replace these fuses. The

fuses are socketed and are field-replaceable.

Replacement fuse kits are available from ALC (Part no.

FUSEPKG).

Production Date

The production date of the module can be determined by

a sticker on the back of the module. The first three

characters indicate the type of module. The next three

indicate the date (year/month/week) of manufacture. The

month digit is in hexadecimal. The last four characters

are ALC production codes.

Figure 17: Power and CMnet Fuses