Automated Pet Care Products LITTER-ROBOT Benutzerhandbuch - Seite 18
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Haustierpflegeprodukt Automated Pet Care Products LITTER-ROBOT herunter. Automated Pet Care Products LITTER-ROBOT 19 Seiten. Self-cleaning litter box
Auch für Automated Pet Care Products LITTER-ROBOT: Handbuch (16 seiten), Handbuch (18 seiten)
Seite druckenHow do I clean the Litter-Robot exterior?
Cleaning the Litter-Robot exterior is easy. Just remove
the Globe and the drawer and give them a sponge bath,
or take them outside for deep cleaning with the garden
hose. All other surfaces can be wiped clean but should
not be submerged.
CAUTION: The Base of the Litter-Robot contains
electrical components and is not meant to be
submerged or wet. See the "Cleaning the Litter-
Robot" section for more details.
What are the dimensions of the Litter-Robot?
•
The fully assembled Litter Robot is 29" high, 22"
wide and 24" deep.
•
The waste drawer is 11" wide, 16" long and 6" deep.
•
The oval shaped entry for the cat is 9" high and 6
½" wide.
•
The litter bed area measures 14" across at
maximum litter capacity.
•
There is 13" to 15" of head room for the cat inside
the Globe depending on the level of litter. The
inside width is 20" across at the widest point, and
depth is 15" front to back.
40 W. Howard, Suite B-5, Pontiac, MI 48342
Toll Free: 877-250-7729 Fax: 248-253-1797
www.Litter-Robot.com
32
Troubleshooting
1. All lights on the Control Panel are blinking once per
second.
If the Globe cannot find the home position, all three
lights on the Control Panel will blink at a rate of
once per second. Make sure the Litter-Robot is on a
level surface. If the condition persists, please
contact Customer Service.
2. Yellow light on the Control Panel is on.
The Yellow light normally comes on to indicate that
the Litter Robot is in the middle of the clean, fill, or
empty cycle. If the yellow light is on and the globe
is not turning, the cycle has been interrupted by the
Cat Sensor. The Litter-Robot will wait 15 seconds
before attempting to resume the cycle. If the Cat
Sensor is continuously interrupted for more than two
minutes the globe will remain stationary and the Red
light will start flashing.
3. Red light ("Sensor/Timing") on the Control Panel is
flashing.
This condition indicates that the Cat Sensor was
triggered continuously for more than two minutes.
a. Check to see that the Litter-Robot is on a
level surface.
b. Make sure that there is no excess litter in
the Globe. The litter level should be at least
two inches below the bottom rim of the cat
entry opening.
33
40 W. Howard, Suite B-5, Pontiac, MI 48342
Toll Free: 877-250-7729 Fax: 248-253-1797
www.Litter-Robot.com