Celect CC816WHB-0-DF Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Handbuch für Thermostat Celect CC816WHB-0-DF herunter. Celect CC816WHB-0-DF 5 Seiten. Radio controlled thermostat

Seite drucken
the off position before installing, removing, cleaning, or servicing this thermostat.
 Read all of the information in this manual before installing this thermostat.
 Only a professional contractor should install this thermostat.
 All wiring must conform to local and national building and electrical codes and ordinances.
 This thermostat has a removable fuse to protect the system from damage. If system is not
operating properly, check wiring and replace fuse if necessary.
 Use this thermostat only as described in this manual.
Remove assembly screws from the base of thermostat. Gently pull the upper housing straight off
1.
the base. Forcing or prying on the thermostat will cause damage to the unit. See figure 1-2.
2. Install two fresh "AA" alkaline batteries in battery compartment. Be sure to match positive (+) ends
of batteries with positive (+) battery terminals in the battery compartment. See figure 3.（Note: the
product long time not use it, please take out the battery, prevent the battery fluid leakage,
damaged products.）
3. Push power base into wall.
4. Using mounting screws mount the power base to the wall. Place a level against bottom of base,
adjust until level, and then tighten screws. (Leveling is for appearance only and will not affect
thermostat operation.)
5. Replace the upper housing on the base and fix the upper housing by removed assembly screw.
1
4
Assembly Screws
MOUNTING AND WIRING DIAGRAM
2
Upper Housing
Base
Pull the upper Housing
3
Dail
5
Page 2 of 5