DaytonAudio DTA-100LF Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken DaytonAudio DTA-100LF herunter. DaytonAudio DTA-100LF 9 Seiten. Desktop low-frequency amplifier with eq

Seite drucken

Rear Panel

1. Auto On - This feature is handy feature when using the DTA-100LF in conjunction with

other audio equipment and can automatically turn on when audio is detected. (pg. 6)

2. EQ - The single band EQ set on the front panel can be deactivated by completely

removing it from the signal path. Enabling the EQ function will drop the overall output

level of the amplifier by 6dB. This is to allow up to a 6dB boost using the EQ knobs

without the risk of over-driving the amplifier.

3. Line Output - Stereo RCA jacks allow the line level stereo input signal to be output

to other audio equipment. This full range signal mirrors the audio on the input and is

not summed to mono or affected by the gain, EQ, low pass filter, phase, or subsonic

filter adjustments.

4. Line Input - Stereo RCA jacks receive the audio signal from standard line-level audio

sources. When possible, both the left and right audio inputs should be connected and

are internally summed to a mono output. If using a mono RCA SUB OUT or another

mono input source, simply connect it to the LEFT RCA input and leave the RIGHT RCA

input disconnected.

5. Subsonic Filter - Adjusts the 12 dB/oct high-pass filter from 0 Hz to 100 Hz. This helps

remove subsonic information from the signal and tighten the low-end response of some

subwoofer systems. This can be particularly useful for protecting ported subwoofer systems.

6. Speaker Output - Speaker level output connections carry the amplified signal to a

passive subwoofer or bass shaker. The included terminals can accept bare wire, spade

plugs, or banana plugs. The minimum rated load for the DTA-100LF output is 4 ohms.

7. AC Power - The DTA-100LF is capable of 110V and 220V operation. The internal power

supply can automatically sense the power input and operate appropriately; simply

connect the appropriate AC power cord to your wall outlet.

8. Power Switch - The rear panel power switch turns the amplifier on and off. When the

front power indicator is red, the amplifier is in standby mode. When the LED is blue, the

amplifier is fully active.