HiBoost F27-5S Handbuch zur Schnellinstallation - Seite 3

Blättern Sie online oder laden Sie pdf Handbuch zur Schnellinstallation für Verstärken HiBoost F27-5S herunter. HiBoost F27-5S 7 Seiten.

NOTE: Vertical distance is more important than horizontal

distance. If you are unable to obtain the required distance

horizontally, try raising the outdoor antenna to a higher level.

5. Route the coax cable from the Outside Antenna to the Signal

Booster and attach it to the connector labeled "Outdoor."

Connect another coax cable to the connector labeled "Indoor"

and route it to the Indoor Antenna.

NOTE: Be careful not to bend the center pins on the connectors

when securing connections.

6. Once you have ensured all connections are tight, plug the

power supply into the Signal Booster input marked "POWER"

and then into an AC surge protector power strip with a

minimum 1000 Joule rating.

7. If the booster is working and adjusted correctly, the LEDs on

the front panel will be green and the LCD panel will show the

downlink power level (in dBm units). The Automatic Level

Control (ALC) will try to adjust the downlink output power to

the maximum level consistent with the constraints of your

installation and the signal level that is received from the local

tower.

If you have made the most appropriate installation per the

above procedures, but the Signal Booster's ISO or ALC icons

are flashing on the LCD panel (especially if the installation

location is close to the cellular tower) you may also try

reducing the booster gain as described in Manual Gain

Control Operation Chapter of User's manual.

A. Press the "SET" button for more than 3 seconds. It will go into

the "Manual Gain Setting Mode" (MGC) and make one of the

gain values start to blink.