DaytonAudio WP65WT Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner DaytonAudio WP65WT herunter. DaytonAudio WP65WT 4 Seiten. 6-1/2" ip66 indoor/outdoor pendant speaker pair 70v/100v with 8 ohm bypass white

Seite drucken

Congratulations on the purchase of your Dayton Audio

all-purpose speaker is designed to deliver reliable, high-quality audio in commercial and

residential applications, while withstanding outdoor environments. The WP65WT features

an IP66 weather-resistant ABS construction, 2-way coaxial speaker design.

• 6.5" woofer with coaxial 1" tweeter

• Versatile mounting brackets for pendant mount, wall mount, or landscape applications.

• Integral 70V transformer with selectable taps and 8 ohm bypass

• Suitable for indoor or outdoor installation

Please read these instructions completely before you begin your installation.

1) Speaker Connection

Remove about 8" of the cable jacket to expose the inner conductors. Strip 1/4" of in-

sulation from each conductor and connect to the speaker terminals. When connect-

ing the wires to the speakers, be sure to observe proper polarity for the best sound.

Most CL2 rated speaker cable will have red and black colored wires inside the

jacket. Connect the red wire to the (+) terminal and the black wire to the (-) terminal.

The red (+) and black (-) speakers wires should correspond to the same terminals

on the amplifier.

NOTE: If this speaker will be used with a 70V/100V distributed audio system, do

not set the 70V/100V tap to the 8 ohm setting. Doing so may damage your speaker

when playing. To use this speaker with a conventional (non-70V/100V) audio sys-

tem, change tap to the 8 ohm setting. If you are unsure what type of audio system

you have, consult a professional installer before continuing.

Step 1: Remove the speaker end cap

Using a screwdriver or other flat-blade tool, turn the tap selector knob to the desired

setting. Selecting the 8 ohm setting will remove the transformer from the signal path

and allow a conventional amplifier to drive the speaker. If using a 70V/100V system

choose the appropriate output setting for the application.

Step 2: Reinstall speaker end cap

Once you have selected the correct setting and mounting bracket you can feed the

speaker wire through the end cap and reinstall.

Typical 70V/100V installation wiring method

WP65WT speaker. This rugged,