GAI-Tronics Clean Phone 295F Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Telefon GAI-Tronics Clean Phone 295F herunter. GAI-Tronics Clean Phone 295F 19 Seiten.

Model 295F and 295W Clean Phone™ Telephone

Local Programming

Entering the Local Programming Mode

To program the Model 295 Clean Phone locally, you must enter the local programming password, which

is fixed and cannot be changed. Enter the key sequence # 1 2 3 to access the local programming mode.

The unit will emit a high pitch beep for each correct key pressed. The light under the front panel

ON/OFF button will begin blinking at a slow rate to indicate the programming mode has been entered. If

an incorrect key is pressed, you will hear a single low pitch beep to warn that the password is incorrect.

Following the correct entry of the local programming password, the unit is in a programming mode where

the user may program the unit as desired. For programming instructions, see the Programming Table.

Each digit of the local programming password must be entered within 5 seconds of the one before it. If a

digit is not entered within the 5-second limit, the unit will emit a single low pitch beep and exit the local

programming mode. If the unit times out waiting for the password, or if the password entered incorrectly,

the unit will automatically exit the local programming mode.

The unit will ignore any incoming calls when in the local programming mode.

Exiting the Local Programming Mode

There are two ways to exit the local program mode:

•

If there is no keypad activity for 20 seconds, the unit automatically exits the local program mode.

•

The user can terminate the mode at any time by pressing the ON/OFF button.

•

The unit will emit a short low pitch beep and turn off the light under the ON/OFF button

d:\standard ioms - current release\42004 instr. manuals\42004-146h.doc

11/05

Pub. 42004-146H

9 of 17

Page: