GAI-Tronics PMA-300 Handbuch - Seite 9
Blättern Sie online oder laden Sie pdf Handbuch für Verstärken GAI-Tronics PMA-300 herunter. GAI-Tronics PMA-300 14 Seiten. 300 watt central amplifier
Model PMA-300 300 Watt Central Amplifier
Speaker Out Connection
The amplifier's SPEAKER OUT connection uses a keyed, positive-locking Neutrik® SPEAKON
connector, which eliminates the possibility of vibrating loose. The 'keyed' feature prevents
misconnection to similar style connectors on the amplifier's rear panel. The amplifier contains a 70V out
and a 100V out connection depending on your constant voltage speaker system.
Notes:
•
Use only one of the SPEAKER OUT connections at a time.
•
If using the 100V out connection, only CLASS 1 wiring specification is acceptable.
•
If using the 70V out connection, CLASS 2 wiring specification is acceptable.
Connect the speakers as follows:
1. To properly terminate to the system speaker cable, use the enclosed SPEAKON™ connector (blue
body), which is supplied with the unit.
2. Determine which SPEAKER OUT voltage, 70.7V or 100V, is required for your constant voltage
speaker system.
3. Determine the desired wire gauge per the Speaker Wire Guidelines chart on page 6.
4. Determine the correct clamping strain relief depending on your cable's diameter.
5. For 100V Speaker Systems: Connect the audio (+) wire to pin 1 (+) and audio (-) wire to pin 1 (-)
(markings are embossed on body of connector) and tighten securely.
Note: Terminals 2 (+) and 2 (-) are not used. Refer to Figure 4 for connector location.
6. For 70.7V Speaker Systems: Connect the audio (+) wire to pin 2 (+) and audio (-) wire to pin 2 (-)
(markings are embossed on body of connector) and tighten securely.
Note: Terminals 1 (+) and 1 (-) are not used. Refer to Figure 4 for connector location.
Speaker System's Voltage
Output Needed
100 V
70.7 V
f:\standard ioms - current release\instr. manuals (42004)\42004-667l2a.doc
12/00
Corresponding Load Impedance (ohm)
for 300W (Full output)
33.4 ohm
16.7 ohm
8 of 13
Page
Pub.: 42004-667L2A
TM