Greatneck 80122 Benutzerhandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kraftschraubendreher Greatneck 80122 herunter. Greatneck 80122 17 Seiten. 4.8 v cordless pivoting screwdriver

Seite drucken

FORWARD/REVERSE SWITCH

The cordless screwdriver is equipped with a

convenient switch that functions as both an

ON/OFF switch and FORWARD/REVERSE

switch.

To drive screws, press the right hand

side of the switch (1) (Fig. 3). To turn

the switch OFF, release the switch.

To remove screws, press the left hand

side of the switch (2).

PIVOTING HANDLE

The handle of the cordless screwdriver is

designed to pivot to various angles. This

feature allows you to configure the tool for

easier access in hard to reach locations. It

also makes it easier to apply extra torque in

manual mode.

To pivot the handle, simply "bend" the tool

in the middle to the appropriate angle (1)

(Fig. 4)

ASSEMBLY & OPERATION

Fig. 3

Fig. 4

PREPARING SCREW HOLES

It is important to prepare screw holes

before attempting to fasten two pieces of

wood together. Proper preparation will

make screws drive easier and prevent

misaligned components, stripped screw

heads, splitting and separating of wood

components.

Clamp components that are to be

screwed together in their desired

position (Fig. 5).

Drill a pilot hole (1) through the outer

piece (2) and into the inner piece (3).

Drill hole 2/3 the diameter of the

smooth portion of the screw shank.

NOTE: If the wood is soft, drill the hole

2/3 the length of the screw. If the wood

is hard, drill the hole the full length of

the screw.

Remove the clamp from the two pieces

to be screwed together.

Enlarge the hole (1) in the outer piece

(2) so that it is the same size as the

smooth portion of the screw shank

(Fig. 6).

If using a flat head screw, counter-sink

the hole (4) so the head of the screw

will be flush with the surface when fully

driven into place.

Fig. 5

Fig. 6