Greatneck 80122 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kraftschraubendreher Greatneck 80122 herunter. Greatneck 80122 17 Seiten. 4.8 v cordless pivoting screwdriver

Seite drucken
CORDLESS
SCREWDRIVER SAFETY
!
WARNING:
plug in your charger, charge the battery
or operate the tool until you have read
and understood this Owner's Manual.
Always use safety goggles or other
suitable eye protection.
Hold the tool by its insulated gripping
surfaces when driving screws in areas
where the screws may contact hidden
wiring. Contact with a "live" wire will make
exposed metal parts of the tool "live" and
can shock the operator. Do not drive
screws or break into existing walls or other
blind areas where electrical wiring may
exist. If this situation is unavoidable,
remove all fuses or disconnect all breakers
feeding the work area.
Secure the workpiece in a vice or with
clamps. Never hold it in your hand or
across your legs. The rotating action of
the screwdriver may cause the bit to come
loose from the screw and cause injury.
Never carry the cordless screwdriver
with your finger on the ON/OFF switch.
The tool is always in an "ON" condition
when the battery is charged.
Never hold the body of the cordless
screwdriver near the ON/OFF switch
while changing screwdriver bits.
Accidentally touching the ON/OFF switch
may start the tool and possibly cause an
injury.
Always use the correct shape of
screwdriver bit that matches the head of
the screw.
For your safety, do not
Always use the largest size screwdriver
bit that will properly fit into the head of
the screw.
Do not use worn or damaged
screwdriver bits. Worn or damaged
screwdriver bits will not drive the screw
properly and may jump out of the screw
head, causing possible injury.
Always install the screwdriver bit or
magnetic bit holder fully into the collet.
If not fully inserted, the bit or magnetic bit
holder may jump out of the collet and cause
damage to the workpiece or possible injury.
BATTERY & CHARGER
SAFETY
Never attempt to open the battery for
any reason. If the housing of the battery
breaks or cracks and allows leakage
through the handle, immediately
discontinue use and do not recharge the
cordless screwdriver.
Do not charge the battery if the tool is
wet or shows any evidence of battery
leakage.
Minor leakage from the battery may occur
under extreme use, charging or
temperature conditions. This does not
indicate a failure. If however, the outer
seal is broken and this leakage gets on
your skin, follow these steps:
1.
Wash immediately with soap and
water.
2.
Neutralize with a mild acid such as
lemon juice or vinegar.
3.
If liquid gets into your eyes, flush
immediately with clean water for a
minimum of 10 minutes and seek
medical attention.
NOTE: The battery liquid is
20–35% solution of potassium
hydroxide.
6