GreatWhite GW9500 Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schwimmbad-Staubsauger GreatWhite GW9500 herunter. GreatWhite GW9500 12 Seiten. Automatic pool cleaner

Seite drucken

Figure 19

Make sure Oscillator

is partially inserted in

chamber while reinstalling

Shaft Assembly

Oscillator

Chamber

Figure 20

Figure 21

Start here with

large button when

installing vacuum skirt.

'Outside' will show

(facing out) when

skirt is correctly installed.

Figure 22

If you have any questions, please call 1-800-752-0183

ABOUT ASSEMBLY

1894 0795

Swing Cam

Arm up for

Clearance

O U

Rubber

T S

I D E

vacuum skirt

1893 0795

1. Put both white seals in the oscillator; hold them in

place.

2. Install the oscillator on the long gear shaft. Install the

ratchet gear on the shaft so that the teeth engage the

ratchet on the oscillator. Install the spring, ratchet

drum, pinion gear (large gear first), and cam (gear end

first) on the shaft (See Figure 19). Hold the gears on the

shaft while installing them, and compress the clutch

spring to allow assembly to slip into place between the

posts (See Figure 19).

3. Install the long gear shaft and end blocks in the clean-

ing head with the large arm of the cam down (see

Figure 20).

4. Reinstall the short gear shaft and two gears (See Figure

21); the small pinion gears and the shaft pin go on the

side toward the end of the cleaner – away from the

oscillator box. Make sure that the gears engage the

gears on the long gear shaft.

5. Install the oscillator chamber cap and clip it in place.

6. Install the rubber vacuum skirt on the cleaner with the

word 'OUTSIDE' showing. Start at the large pin on the

back of the cleaner head (see Figure 22) and work

around the cleaner. Make sure the skirt is flush against

the stop strips on the cleaner head (see Figure 23).

7. Turn the cleaner over. If you removed the bumper and

brush ring, replace them now.

8. Install the lower body assembly in the shroud. Fasten

the cleaning head in place with 4 screws (2 long, 2 short

– see Figure 24).

NOTE: Make sure that you do not dislodge the rubber

vac skirt while inserting the lower body assembly past

the brush ring.

This

Figure 23

#10-16x1-3/4" Screws

Center

Brush

Location

#10-16x1" Screws

Bottom View of Cleaner

Figure 24

Not

This

1892 0795

Center

Brush

Location

1891 0795