GAI-Tronics 234WM-202 Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Notruftelefon GAI-Tronics 234WM-202 herunter. GAI-Tronics 234WM-202 13 Seiten. Wall-mount stanchion assembly

Seite drucken

Model 234WM-202 Wall-Mount Stanchion Assembly

6. Connect the telephone cable from the surge protection, and feed the cable through the bottom access

hole of the telephone back box and allow it to hang free.

7. Bring the orange and violet strobe unit wires through the bottom access hole of the back box, and

allow them to hang free.

8. The telephone front panel is shipped from the factory with a cable and modular plug attached to TB1.

If desired, an optional modular telephone jack can be mounted to the inside of the back box allowing

the use of the cable and modular plug that is attached to TB1. If the telephone line is to be hard-wired

to the telephone, this cable can be removed and discarded.

9. Attach the telephone cable from the surge protector to TB1 on the telephone PCBA as shown in

Figure 8.

10. Attach the strobe's violet and orange control wires to TB2 on the telephone PCBA as shown in

Figure 8.

11. Install the telephone's front panel using the six tamper-resistant screws and six washers provided.

: Excessive tightening will cause the panel to warp. Do not over-tighten.

OTE

Wiring Power Connection

All wiring connections should be complete at this point, with the exception of the stanchion panel light

and strobe wire connections to the incoming power lines. All connections must be made in accordance

with the National Electrical Code (NEC) in the United States or the Canadian Electrical Code (CEC) in

Canada. Install the power lines per Figure 8 for ac installations or Figure 9 for dc installations.

Figure 8. Interconnection Diagram with AC-Powered Strobe

p:\standard ioms - current release\42004 instr. manuals\42004-308g.docx

04/16

Pub. 42004-308G

Page 9 of 11