Automatic Technology 14879 Einbauanleitung - Seite 2
Blättern Sie online oder laden Sie pdf Einbauanleitung für Schalter Automatic Technology 14879 herunter. Automatic Technology 14879 2 Seiten. Smart phone control kit, smart hub
Seite drucken
Smart Hub Set Up
Mounting the Hub
a. Determine whether you are going to wall mount the
hub.
i. If hub is to be placed on bench, simply connect to
power supply
, turn on and proceed to installing
2
the Transceiver.
ii. If hub is to be wall mounted follow steps below.
b. To wall mount - Use wall bracket
mark where to drill holes. Pre-drill holes.
i. For plaster walls - insert (2) two Plastic wall plugs
into holes, place wall bracket over holes and affix
with (2) two self tapping screws
ii. For brick walls - place wall bracket
affix with (2) two self tapping screws
c. Slide the hub over the bracket.
d. Connect the power supply
This device must be connected to power at all times. DO NOT disconnect power after setup.
Mounting the Transceiver to the Opener
a. Disconnect the power supply to the opener and
open the main cover.
b. Connect the harness
control board, before attaching to the network
transceiver module
6
c. Thread the antenna cable
shown and connect to the network transceiver
module.
:DCB-05
requires
additional
Secure with glan provided.
:NES500/800 the antenna cable enters the unit
through the bottom plate.
d. Place the network transceiver inside the opener /
controller.
e. Close cover.
f. Download the ATA App and follow the instructions
in the App to setup new smart hub.
g. Use a programmed remote and run the door
through a few cycles which will update the unit with
the details of the transceiver module.
Warranty
WARRANTY
ACCESSORIES
as template to
3
.
5
over holes and
3
.
5
and turn on.
2
to NETWORK on the
7
as shown.
through the unit as
8
hole
in
cover.
1 year
4
6
7
8
DCB-05 connection
6
8
7
Neoslider connection
This warranty is to be read in conjunction with the owner's copy of
the opener installation instruction.
3
5
1