Gree 13-04582 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Klimagerät Gree 13-04582 herunter. Gree 13-04582 18 Seiten. 3-in-1 mobile air conditioner

• Electrical ratings of the air conditioner are detailed on the rating plate on the back of the unit.

• Basic electrical requirements are listed hereafter. Please make sure to check the following before

installing and connecting your unit.

1. The air conditioner must be grounded ; it is equipped with a LCDI

(Leakage Current Detection and Interruption) power cord and plug

This feature will circuit trip the electrical power source if the nominal

current leakage between the cord shield and either load conductor

exceeds a predetermined value. The cord will remain out of power

until the device is manually reset. This is intended to protect against

electric shock and to reduce the risk of a fire in the power cord or

combustible materials nearby. The cord shield is not grounded and

must be considered a shock hazard if exposed. The cord shield

must not be connected to ground or to any exposed metal.

2. Do not cut or bypass the plug ground prong. If you do not have a grounded outlet available

near the air conditioner, have one installed by a qualified electrician.

3. The power supply rated voltage is ± 6%.

4. Do not connect the unit to an outlet being used by other appliances; ideally, connect to a single

grounded 15A circuit (time-delay fuse or circuit breaker).

5. If the power cord or plug is damaged, call SUNRISE TRADEX Customer Service.

(Some models only)

IXING THE CASTERS

To avoid the risk of causing damages to the air conditioner,

you must install the casters before using the appliance.

1. Open the accessory bag and take the 4 casters out.

2. Recline the unit, one side at a time, to insert the unit into

the base holes. Do not recline the unit more than 45°

from the ground.

3. Screw the casters into the base threaded holes.

NSTALLATION OF THE DRAIN HOSE

(Some models only)

You must fix the drain hose before operating the unit.

1. Take out the drain hose, the hose cap and the clamp

from the accessory bag.

2. Insert the drain hose into the drain hole on the lower

back of the unit. Make sure that the drain hose is

correctly inserted into the drain hole.

3. Put the hose cap on the free end of the drain hose.

4. Fix the drain hose on the rear grille with the clamp.

INSTALLATION

Rear grille

Cap

Clamp

Drain hose

Casters