Hiddenbed AW50 QUEEN Installationsanleitung Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Inneneinrichtung Hiddenbed AW50 QUEEN herunter. Hiddenbed AW50 QUEEN 10 Seiten.

Seite drucken

MOUNT TO THE WALL

Using a studfinder,

locate three wall

studs to be at-

tached to (one near

the center of the bed, and

one on each side). Draw a

vertical pencil line that will

appear above and below

the top assembly. Move the

Hiddenbed to the desired

location and lift and lock the

bed in the up position.

(CAUTION-The unit is un-

stable and may try to fall

over. DO NOT leave unat-

tended in this position!)

Push some folded card-

board between the cabinet

sides and bed tray on each

side to assure even spac-

ing. Mark the wall at each

upper corner of the cabinet,

then cautiously unlock and

lower the bed. Attach to the

wall studs by driving 2 1/2"

screws through the top as-

sembly backrail, close to

the top, at the stud points

marked for alignment.

YOU MUST HIT STUDS,

as sheetrock or paneling

will not hold the bed up!

INSERT MATTRESS-

Strap and buckle your

mattress (10" thick or

less) into the tray and

tuck the excess strap-

ping under one side.

CONNECTING THE LEVER ARM

Raise and LOCK the bed in the up position. Hold the

desk wing and pull the lever arm down to the bearer,

then release to connect gently with the bearer. Verify that

the desk is sitting fully up to the side panel. If it is not,

slightly loosen the bearer bolts allowing it to do so, then

retighten securely. Then apply screws to each of the

three flange holes of the bearer fittings on each end of

the desk. One lever arm at a time may be released for

screw access.