Gainsborough G+ LOCKSET Installationsanleitung Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Durch Schlösser Gainsborough G+ LOCKSET herunter. Gainsborough G+ LOCKSET 8 Seiten. G+ series for the apex electric locksets and volt electric locksets

Seite drucken

Task 4

Press these two

buttons together

Teach mode

activation –

via paper clip

• Installing the batteries into the G+ Keys.

• Remove the battery compartment cover by twisting

anti-clockwise and lifting off.

• Insert two batteries + side up (as per diagram above).

• Replace the battery compartment cover and twist

clockwise to lock.

• Perform the following steps to program G+ Keys to

the lockset.

1 The teach button is accessed through the small hole in

the face plate of the Battery Box Transmitter (on the door).

To place the lockset into teach mode, press and hold the

teach button with a paper clip, or similar, until the lockset

emits a teach confirmation sound (1 long; 2 short beeps)

then release the teach button. This should take approximately

3 seconds.

NOTE: you have 10 seconds to perform steps 2 and 3 before teach

mode times out and reverts back to any previously taught G+ Keys.

2 On the first G+ Key to be taught, press buttons 4 & 5

(diagram 17). These buttons must be pressed simultaneously

until the lockset emits a single beep.

3 Repeat step 2 for each G+ Key to be taught. Each additional

G+ Key must be added within the 10 seconds otherwise

the lockset will time out and replace any previously taught

G+ Keys with the keys taught in this session.

4 Once the last G+ Key has been taught, wait for the

lockset to emit the teach mode session finish beeps,

(1 long; 1 short; 1 long).

NOTE:

• If no G+ Keys are taught during the teach session, the lockset

will revert back to any previously taught G+ Keys.

• For doors up to 40mm thick use 2 "short" screws.

• For doors 40mm and over use 2 "long" screws.