ADEMCO 5805-6 Einbauanleitung

Blättern Sie online oder laden Sie pdf Einbauanleitung für Transmitter ADEMCO 5805-6 herunter. ADEMCO 5805-6 2 Seiten. Wireless key transmitter

Seite drucken

INSTALLATION INSTRUCTIONS

GENERAL INFORMATION

The 5805-4/6 is a compact, 4-button or 6-button

portable wireless transmitter intended for use

only with wireless alarm systems that support

5800 Series receivers.

Each button on the

transmitter may be programmed for any zone

response, but is typically used for arming and

disarming.

This device supports the High-Security mode,

which sends rolling-code encrypted messaging

to the RF receiver.

Important Note: This device must be used

with a 5881EN or a 6128RF(UL version)

receiver.

The 5805-4/6 is powered by one replaceable

lithium battery designed to provide up to 4

years of life.

For battery installation, see

Replacing the Batteries.

PROGRAMMING

Each 5805-4/6 is assigned a unique serial

number during manufacturing. Each button on

the unit also has a distinct "loop" number (refer

to Figure 1) that you must program into the

control panel during installation. Assign each

button to an individual zone and designate the

Input Type as "BR" (Button Type RF).

When you are prompted for the serial number,

both press and release twice the button you are

programming, or enter it manually through the

keypad.

For complete details on how to program the

5805-4/6 transmitter's serial number at the

control panel, see the control unit's installation

instructions.

Note:

Buttons on this transmitter must be

pressed for at least 1/2 second to activate the

transmitter.

This feature minimizes the

possibility of accidental transmissions.

ACTIVATING HIGH-SECURITY MODE

If Programming 5805-4/6 in the Control

Program the button in the control.

After

programming

programming mode and wait 60 seconds.

Put the system in Go/No Go mode.

WIRELESS KEY TRANSMITTER

NOTE:

mode, and repeat this procedure from Step 3.

If Programming the 5805-4/6 Locally in the

6128RF

Hold Loop 1, Loop 2, Loop 3 and loop 4 Down

To enroll the First serial number in the

6128RF.

Hold Loop 1, Loop 4 of first Serial # and Loop 2,

loop 3 of Second serial # to enroll Second serial

number in the 6128RF

IF USING TWO RECEIVERS IN HIGH-

SECURITY MODE

Enroll the 5805-4/6 into the receivers one at a

time, by disconnecting Receiver #2, enrolling as

described in "Activating High Security Mode"

(above).

complete,

exit

reconnect

enrollment procedure.

proper High Security operation with both

receivers.

To enroll hold Loop1, Loop2, Loop3 and

loop 4 down at the same time until the

panel beeps.

To sync the device in High Security Mode,

press any button ONCE, until the panel

beeps indicating receipt.

For Second serial number Hold Loop1,

Loop4 of first Serial # and Loop 2, loop3 of

Second serial # at the same time until the

panel beeps.

If no beep is heard, exit Go/No Go

Exit Go/No Go mode (user code + 1 (OFF)).

Figure 1: 5805-6 showing button designations

Note 1: To get second serial Loop 1 you need to

press and hold Serial # 2 Loop3 and Loop

2,To get Second serial loop 4 you need to

hold Serial # 1 Loop 3 and Serial # 2 loop 2

Then,

disconnect

Receiver

#2,

and

This process ensures

5805-4/6

Receiver

#1,

repeat

the