Kintech Engineering Geovane Schnellstart-Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Messgeräte Kintech Engineering Geovane herunter. Kintech Engineering Geovane 2 Seiten.

Seite drucken

GEOVANE | WIND DIRECTION MEASUREMENTS REINVENTED

HOW TO CONFIGURE THIS SENSOR IN EOL MANAGER

Keep in mind that the configuration of a Geovane in EOL Manager has to be done according to its outputs configuration. Open EOL

Manager and go to the data logger you are working on. Open the "inputs" tab and select the following type and model:

Section: Anemometers/Frequency

Type: Geovane

Model: True North Offset

SENSOR

MODEL

SELECTION

Section: Analog Inputs

Type: Geovane

Model: True North Offset

SENSOR

SELECTION

IMPORTANT

After configuring the sensor in EOL Manager make sure

to upload the configuration file to your EOL Zenith data

logger. See the "Quick User Guide" how to upload confi-

guration files to the data logger.

All sensor wire shields must be connected to the data

logger GND terminal.

The data logger should always be connected to a se-

parated ground rod. Not to the lightning rod of the

tower.

For a precise measurement of the True North Offset,

the wind wane coupled to the Geovane must have, at all

times, its internal angular reference perfectly aligned

with the Geovane's angular reference. See section 4 of

the manual.

It is recommended to always keep the RS-485 cores

(pins 2 and 4) accessible from the ground so the Geova-

ne can be re-configured and updated without having to

dismount it.

[email protected]

DATASHEET

DOWNLOAD

MODEL

DATASHEET

SELECTION

DOWNLOAD

STANDARD

CALIBRATION

STANDARD

CALIBRATION

Metallic

Drawing of

measurement

anemometer

mast,

incl. isolator

grounded

Metallic

Drawing of

measurement

anemometer

mast,

without

isolator

grounded

The shield should be

connected to both

the Geovane side and

the data logger side

Data logger should

always be connected

to ground

The shield should

only be connected on

the data logger side

Not on the Geovane

Data logger should

always be connected

to ground

Last modified: 12.03.2018