ActiveProducts XE06 Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Hochdruckreiniger ActiveProducts XE06 herunter. ActiveProducts XE06 10 Seiten. 1600 psi electric pressure washer

Seite drucken

WINTERIZING AND LONG-TERM STORAGE

OPTIMUM WINTERIZING PROCEDURE
Winterizing your pressure washer will help protect and prolong its life. We strongly
recommend you follow the below steps using Pressure Washer Pump Saver (39-8602-0).
This will keep the internal parts lubricated, protected from rust, and prevents the pump
from freezing.
1
Connect Pressure Washer Pump Saver hose onto the adaptor and quick-connect
coupling.
2
Depress button on top of Pump Saver container.
3
Continue until fluid exits the pressure hose.
4
Remove the hose from pump inlet.
QUICK WINTERIZING PROCEDURE
If you cannot do the Optimum Winterizing procedure, you can still protect your pressure
washer from winter-damage by doing below:
1
Disconnect all water connections.
2
Turn on the machine for a few seconds,
until the remaining water in the pump
exits. Turn off immediately.
3
Do not allow high-pressure hose to
become kinked.
4
Store the machine and accessories in
a room that does not reach freezing
temperatures. Do not store near
furnace or other sources of heat as it
may dry out the pump seals.
CAUTION
Drain gun assembly of any remaining water. Aim gun downwards and squeeze trigger.
Recommended: Pressure Washer Pump
Saver (39-8602-0)
13

CLEANING AND MAINTENANCE

Connections
Connections on pressure washer hoses; gun and spray wand should be cleaned regularly
and lubricated with non-water soluble grease.
Spray Tips Only
Clogging of the spray tips causes the pump
pressure to be too high and cleaning is
immediately required. You can clean the
spray tips by carefully inserting the needle,
or a thin, sharp instrument (i.e. paperclip)
into the tip to rid it of deposits.
Water Filter Screen
The pressure washer is equipped with a
water inlet screen to protect the pump.
If the screen is not kept clean, the flow
of water to the pressure washer will be
restricted and the pump may be damaged.
1. To clean inner water screen, remove
quick-connector and remove the filter
screen from the pump inlet.
2. Rinse screen until it is free of debris
and blockage.
3. Replace screen and quick-connector
immediately to prevent any foreign
matter from entering the pump.
14