dB Technologies B-HYPE 8 Schnellstart-Benutzerhandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Schnellstart-Benutzerhandbuch für Redner dB Technologies B-HYPE 8 herunter. dB Technologies B-HYPE 8 4 Seiten.
3) Connections, controls, first turn on
All the connections and controls are in the amplifier
panel side:
1–Combo Balanced Input (for XLR or TRS
connectors)
2–Balanced Link output
3–Volume Control
4–Audio Input Sensitivity (Line/Mic)
5–LEDs (Limiter, Signal, Ready)
6–DSP Preset switch
7–VDE Mains Input (with related fuse)
8–POWER switch (ON, OFF)
B-HYPE 8
www.dbtechnologies.com
a) Connect the audio input (1). The combo connector
allows a TRS or XLR connection. In case of a dynamic
microphone, plug it and select "Mic" in the Audio input
sensitivity switch (4). In the other cases check that the
switch is set on "Line". Put the level of Volume (3) to
the maximum value "MAX".
b) If you need to link B-HYPE 8 to another one, please
use a cable with XLR connectors (not supplied).
Connect the output Link (2) of the first, to the balanced
Input (1) of the second one. In the second loudspeaker,
please check that Audio Input Sensitivity (4) is set on
"Line" position and that Volume (3) is set to "MAX"
value.
c) Set properly the DSP preset switch (6), choosing
between "Flat" and "Boost" configuration. Please note
that "Flat" position does not affect the frequencies
equalization, while "Boost" acts enhancing lower and
upper frequencies.
d) Plug properly the mains VDE input cable (supplied)
in the related input (7). Check that the audio source is
set on the minimum level. Then switch the POWER
switch (8) to "ON" position. Increase gradually the
volume of the audio source to the desired level. The
Ready LED (5) is steadily on, the Limiter LED shortly
flashes, the Signal one starts blinking at the presence
of audio signal.
Check the site
information, for added accessories and for the
complete user manual!
www.dbtechnologies.com
Rev 1.3 cod. 420120254Q
for further