Gait up Physilog 5 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör Gait up Physilog 5 herunter. Gait up Physilog 5 17 Seiten.
Auch für Gait up Physilog 5: Benutzerhandbuch (12 seiten), Benutzerhandbuch (17 seiten)

Seite drucken

Gait Up SA

EPFL Innovation Park, Bat C. CH-1015 Lausanne

www.gaitup.com

TVA CHE-145.136.760

Briefly, the first mode one is called "Physilog Measure" and allows to start and stop data recording

of the Physilog® of up to two sensors at the same time. When pushing the "Start measurement"

button, the connected Physilog start recording and sending the data file to the tablet. When

launching two Physilog®5 at the same time using the tablet application they can be synchronized in

post-processing in Matlab.

The data is streamed to the tablet during the measurement. For high sampling frequencies (over

64Hz) and multiple Physilog®, the data transfer encounters some delay and remaining data is

transferred after the end of the measurement.

Data saved on the tablet only contains accelerometer and gyroscope data, even if the barometer

was turned on. The original data with all sensors is saved on the Physilog®.

During the measurement, the Physilog®5 blinks green where each blink is made of two short flashes.

To stop the measurement, click on the "Stop measurement" button in the application. In case the

sensors have not sent all data to the tablet during the measurement, they twinkle orange to show

that data transfer is still ongoing. The tablet application shows the percentage of the file already

transferred.

The second mode is called "Physilog Visualize", it can be used to check if the sensor's data looks as

expected. Up to 4 sensors can be connected to the application at the same time for this mode. The

"Physilog Visualize" starts displaying data from connected sensors automatically (no start button).

It does not store the data, neither on the tablet nor on the Physilog®. During the measurement, the

Physilog®5 blink green where each blink is made of two short flashes. To stop data streaming either

disconnect the sensor or exit this part of the application.

Note: Bluetooth 4.0 or higher is required on the mobile device to be able to communicate with

Physilog®5.

Physilog5 user manual v1.2.6 Date: 19.06.2018