Dynamic Flight Manta Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Sport & Draußen Dynamic Flight Manta herunter. Dynamic Flight Manta 10 Seiten. Hang gliding harness

Seite drucken

First slide the parachute bridle into the UV protective sleeve supplied. Next slip the bridle

onto the carabiner behind the main riser webbing. Fasten the bridle to the main riser using the

velcro sleeve. Lay the bridle into the parachute container using an S-fold method. Do not

stow the bridle with rubber bands. Place the deployment bag on top of the bridle in the

parachute container. If required securely attach the supplied deployment handle to the

existing deployment bag handle then through itself. Close the container by passing the short

bungie loops through the grommets in appropriate sequence, then use the deployment handle

rope to trap these loops on the outside of the container. A packing string passed down

through the grommets, starting from uppermost and working down to the bungie loop, then

back up in reverse order will simplify this procedure by allowing the loops to be easily pulled

up through the grommets. Close the velcro flap. Once the container is closed check that the

parachute is secure by vigorously applying a knee behind the container to see if it causes an

accidental deployment. Also ensure that sufficient bridle is free that the movement of the

slider is not restricted. After fitting a parachute for the first time have a hang in the harness

and ensure you can easily reach the deployment handle and that when you pull it your

parachute comes out of the container. Failure to correctly pack your parachute into your

harness may result in an inability to deploy your parachute when you need it. This may result

in serious injury or death. If unsure consult your dealer.

Cleaning procedure

It is recommended that you do not use any detergents to clean your harness. Most detergents

are alkaline and will weaken the harness structure. If you insist on using a detergent use only

one that has been specially formulated for cleaning sailcloth. It is preferable to use only a

damp cloth to wipe off any dirt and then allow your harness to air dry out of direct sunlight.

Better still keep your harness clean in the first place.

Salt water immersion

If you land in the ocean and manage to retrieve your harness you must follow the following

steps to avoid serious damage to your harness and parachute. When salt water immersed

fabric dries microscopic salt crystals are left behind. These act like miniature knives, which

cut the fibres of the harness webbing and fabric. The recommended procedure used by

parachutists is to keep everything completely wet with salt or preferably fresh water. Do not

let things dry out. Remove all removable metal items. Open all zips and pockets. The

parachute will need to be removed from its container and deployment bag. The entire sodden

mass is then placed in a garbage bin or bath tub and a series of fresh water flushes are applied

– the more the better. Once all the salt has been rinsed out the material is air-dried out of

direct sunlight. In testing decreases in strength of up to 50%+ have been reported following

salt-water immersion and drying without rinsing. Correctly rinsed 90%+ of the original

strength is retained. Never land in surf.

Periodic inspection schedule

These guidelines are based on experience with the problems, which can and do occur with

harnesses. It is strongly recommended that you follow them to ensure your harness gives

optimal service. Inspections are due after the stated number of flying hours or the elapsed

period of time, whichever is the sooner.

Preflight

Check ropes are not tangled and make sure their ends are correctly located on their respective

velcro tabs. Ensure internal zippers are closed, and boot zipper is fully undone. Check head

up/down adjustment rope is cleated off so you will hang above the base tube when in prone.

Check parachute container is securely closed.

positive locking function.

Check Stubai buckles and carabiner for