Hidrotermal ARS-12.5 Handbuch für Installation und Wartung - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Wartung für Wasserspender Hidrotermal ARS-12.5 herunter. Hidrotermal ARS-12.5 12 Seiten. Automatic residential softener

Seite drucken

7.4 The operations of the Valve with The Function of Mixing Water

If the users think the hardness of outlet water is too low, they can adjust the hardness by using the

function of mixing water according to the actual demand.

Operation: Anticlockwise rotates the adjusting bolt (As the picture shows.) The wider angle is, the

higher outlet water hardness will be.

8. Usage Illustration

After installing the device and setting the relevant parameters,please conduct the trial running as

follows:

※Fill the brine tank with the planned regeneration salt and the water(Refer to the below table), making

the brine is saturated(26%). Then start the device (This step is necessary only for the situation that the

device is put into use for the first time.)

Resin Tank

0713

Water(L)

※ Switch on power. Press"

position(Avoiding to open the valve too quickly to damage the device and make the resin run off). At

this moment, you can hear the sound of air-out from the drain pipeline. After all air is out of pipeline,

then open inlet valve completely and conducting 2-3 minutes backwash, cleaning the foreign materials

in the resin tank until the outlet water is clean.

※Press "

" turn the status from Backwash to Brine& Slow Rinse. Under this status, the brine will be

absorbed from the brine tank into the resin and the resin is regenerated. After absorbing, the brine

valve will close. The system will still conduct about 15 minute's slow rinse, wiping off the residual brine.

The whole process will take about 40 minutes to finish.

※Press "

" and turn into Brine Refill status. The brine tank will be refilled with water to dissolve the

salt. When the level controller reaches the required height, the refilling will be stopped. The new

saturated brine will be used for next regeneration.

Bypa

0717

0815

0817

4.5

" and go in the Backwash status. Slowly open the inlet valve to 1/4

Water System

Back Washing...

02:40:25

Water System

Brine & Slow Rinse...

Up-flow

Remaining: 30 min.

03:15:50

Water System

Brine Refilling...

Remaining: 05:30 min.:s.

Hard-water

Mixing Button

0917

1017

0835

02:08:00

Backwash Status

Brine & Slow Rinse Status

Brine Refill Status

0935

1024

1035

13.5

1044