Celexon HomeCinema CLR UST Betriebsanleitung - Seite 9
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Projektor-Zubehör Celexon HomeCinema CLR UST herunter. Celexon HomeCinema CLR UST 11 Seiten. Electric floor high contrast screen
Auch für Celexon HomeCinema CLR UST: Betriebsanleitung (12 seiten)
Seite drucken
CHARGING THE REMOTE CONTROLS*
As soon as you notice that the signal from the remote control arrives
irregularly or not at all at the receiver, you must charge the remote controls.
To do this, use the USB cable supplied and connect this to a USB-TYPE DC 5V
power supply unit (not included in the box).
A red signal light lights up during
charging. As soon as it goes out, the
charging
cycle
charging, the remote control can be
used normally.
* Only possible with rechargeable remote controls, otherwise replace the battery with the same type.
CONTROL VIA USB RADIO TRIGGER
ATTENTION: Not every projector can trigger via its USB port. Check with
your projector manufacturer about the trigger features of your projector. The
trigger will only work if the projector's USB port is TRULY unpowered in
standby mode. Install the USB trigger to an available USB port on your
projector. As soon as the projector starts, the screen is triggered and extends
automatically. As soon as the projector is switched off, the screen retracts
automatically. The trigger is already coupled to the screen. If the connection
still does not work, follow the steps below:
1.
Switch the screen ON.
2.
Press the learning button inside the screen (behind
the front of the screen on the left as seen from the
front) by using a paper clip. Press and hold the
button until you hear a beep.
3.
Hold the trigger near the screen.
4.
Press the learn button inside the trigger by using a
paper clip.
5.
Press and hold the button until you see a light signal
on the trigger.
6.
At the same time you should hear a beep from the
screen.
7.
The pairing is successful and completed
is
complete.During
Screen
Trigger
8