Dynamics Dings 71025-EC6S Anleitung Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Industrielle Ausrüstung Dynamics Dings 71025-EC6S herunter. Dynamics Dings 71025-EC6S 8 Seiten. 8700 end mount three phase brake. ip56 (nema 4) housing

Seite drucken

RECOMMENDED TOOLS AND HARDWARE

NOTE: The following tools and hardware are required for installing the brake onto a motor or mounting bracket. Use

proper torque when required to ensure fasteners do not loosen during operation.

•

3/4 INCH HEX WRENCH OR RATCHET/SOCKET

•

3/16 HEX BIT SOCKET (OR KEY)

•

TORQUE WRENCH

•

QUANTITY (4), 1/2 diameter SHCS, MINIMUM 1" LONG (see installation note #5 below)

•

3/8 BALL END HEX BIT SOCKET (KEY OR T-HANDLE)

INSTALLATION

(See Figures 1, & 2, Table 1)

1. Remove hub (99) from brake and position on motor shaft with key according to dimension "N" per ﬁ gure 1.

Stamped part number on hub should face away from motor. Tighten hub set screws with 18 lb.ft. torque.

2. Remove temporary cover nut and cover (67). Set cover aside. Discard temporary nut.

3. If brake is supplied with a mounting face gasket (91), place gasket onto the brake mounting face.

4. Place brake on motor, guiding discs on hub. Use caution not to pinch gasket. For horizontal mounted brakes, the

drain plug should be pointed down.

5. Bolt brake to motor "C" face with four socket head cap screws. See Figure 1 to help in determining proper bolt

length. Final bolt thread pitch, length and mounting torque is dependent on the material and depth of the threaded

holes in the mounting face.

6. Connect coil leads per appropriate wiring diagram in Figure 1 and replace cover (67).

7. Use provided sealing washers (70) and nylon locking nuts (71) to secure cover (67).

4740 W. ELECTRIC AVE. • MILWAUKEE, WISCONSIN 53219 • 414/672-7830 • FAX 414/672-5354 •

BK4773S-3 (6/2017)

Figure 1 - Brake Outline