Hifionics BRUTUS BRX1100.1D Installationsanleitung Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Verstärken Hifionics BRUTUS BRX1100.1D herunter. Hifionics BRUTUS BRX1100.1D 13 Seiten. Brutus brx series amplifers

Seite drucken

BRX160.2 2-CHANNEL AMPLIFIER APPLICATIONS

2 CHANNEL FULL RANGE SYSTEM

Here we show how to use the 2 channel amplifiers as straightforward discrete 2

channel full range units.

Interconnect cable checklist:

- Connect the four inputs of the amplifier to a Radio/CD with quality RCA cables.

Switch setting checklist:

- 1/2CH X-OVER: FULL

MONO

Here we show how to use the 2 channel amplifiers as a 1 channel unit by taking

advantage of the mono bridging capability of all Hifonics amplifiers

Interconnect cable checklist:

- A MONO signal source is required to bridge channel pair 1/2, such as would be

available from the mono sub bass output of an active crossover, whether

standalone, or built into a head unit or equalizer. If you only have 1 set of RCA

outputs from your headunit, you can simply connect those to the inputs for ch

1/2 and switch the MODE to MONO. The amplifier will auto sum the signal and

provide mono output for bridged channels 1/2 once the X-OVER is switched to

LP.

Important: Do not be tempted to connect the hot, or positive outputs, from any

source together to obtain a mono signal, as this could very well damage the

output stage of that source.

- It is necessary to feed the SAME signal to both left and right inputs via a Y-

adapter RCA cable.

- Connect the mono speaker positive terminal to the LEFT +, and its negative

terminal to RIGHT - as shown.

MONO LINE INPUT

(Unless using procedure

listed above for 3ch)

Level control checklist:

- Refer to the section "Setting up systems after installation for best performance"

Minimum final loudspeaker impedances:

- 2 ohm per channel.

BRUTUS

Switch setting checklist:

- 1/2CH X-OVER: LP

-MODE:

Level control checklist:

- Refer to the section "Setting up systems after installation for best performance"

Minimum final loudspeaker impedances:

- 2 ohm per channel in stereo mode.

- 4 ohm mono bridged.

BRUTUS

MONO